Fuse blown | Power door locks inop on 2014-2018 Ford Transit Connect? - How to fix door locks.
$
Ford transit connect power door locks not working:
How to fix door locks on 2014-2018 Ford Transit connect
Check out complete details below and contact us with any questions you may have.
- description
Power door locks stopped working on 2014-2018 Ford Transit Connect - How to fix door locks.
Did your door locks stop working on a 2014 through 2018 Ford Transit Connect? There could be a few reasons but if they stopped working after jump starting your vehicle the answer is simple.
When you jump start a vehicle with a vehicle with an alternator larger than 70 Amps- or even charging with a load that spikes above 70 Amps you likely blew a 70 Amp fuse which is in place by Ford to protect other circuity and components in your vehicle. In the case of the 2014-2018 Ford transit connects, one of those circuits is your power door locks protected by a 70 AMP MIDI fuse which is likely blown.
This is an easy fix if this has happened to you and it should only take 15-20 minutes to replace.
Tools needed:
- Flat tip screw driver
- 8 mm socket and wrench
Optional: Test light or multi-meter
Steps:
- Remove battery cover (simply pulls up and off)
- Remove upper air filter box by disconnecting single electrical connection, pulling two clamps back by your fingers, loosen the hose clamp and pull the upper air cleaner off.
- Remove bottom of air cleaner housing by wiggling and working up and out. (no tools required)
- Identify fuse panel in front of battery then pull wire back and away from panel- this is held in by push pins. Use a screw driver and lightly pry away from cover until pins pull out. NOTE: cover does NOT need removed just pulled back far enough to access MIDI fuses
- Identify the 70 AMP MIDI fuse, it will be the 4th one from the left and it “should be brown”. You can test this with a multi-meter or test light if you have one on hand otherwise if your failure was after a jump start, rest assured this fuse is the most likely cause.
- Replace 70 AMP MIDI fuse using a 8MM socket to remove two nuts holding it in place
- Test door locks- they should be working now!
- Reinstall the fuse cover, air cleaner box and battery cover